Hoozhu U10 Cree XM-L U2 900-Lumen MiNi LED Diving Light for Waterproof 80m Diving Flashlight
Beschikbaarheid: In voorraad
Normale prijs: US$ 37,35
Special Price US$ 33,16
Model No.: U10
LED: CREE XM-L 2 (Max 900 lumens Dive Lamp)
Color Temperature: 6500k
Runtime: High: 2.3 hrs Low: 3.8 hrs, SOS: 3.0 hrs
Three Brightness Levels: High -Low -SOS
Body Material: Durable Aircraft-grade Aluminum
Angle of Light Beam: 15°
Surface Treatment: Premium Hard-anodizing
Color: Black/ Blue/ Red
Battery: 1*18650 BatterY
With battery over-discharging protection, polarity reversing protection
Operation Voltage: 2.9V to 4.2V
Waterproof: 80 Meters Underwater
Dimensions: 124mm (L) * 28.8mm (Dia. of Head)
Resistance: 1.5 M
Weight: 100 Grams (Without Batteries); 133 Grams (With Batteries)
Underwater Weight: 62 Grams (With Batteries)
Switch: Middle - Press On/Off to cycle through high,low,strobe,and the lights will turn off after press and hold switch for 2 seconds.
1.The Diving Light with special fixture.It would be damaged if disassembled at your own discretion.
2.Pl inspect the O-rings carefully every time you finished diving and change the broken O-rings when necessary.
3.After every diving,pl clean the flashlight body with fresh water,and store it properly after full dried.
1.Remove the tail by turning counter-clockwise.
2.Remove used batteries and replace with fresh batteries as shown by the polarity stickers.
3.Mount the tail by turning clockwise.DO NOT ACTIVATE IT YET.
1. Plug the charger in the wall power socket, the indicator light is green in the free-load status.
2. Put the battery in the slot of the charger.
3. The indicator light is red if the batter is not fully charged; It will turn green after fully charged.
4.Take out the fully charged battery and use them in the diving light.
SCUBA DIVING APPLICATION
Check closely for cuts, scratches, or an otherwise damaged O-ring or mating lens surface as this can cause the light to flood under pressure. Remove any salt deposits, sand, dirt, or other foreign matter from the O-ring sealing surfaces.
KEEP THE THREADS, O-RING GROOVE LUBRICATED WITH SILICONE GREASE.
If the light is not to be used for sometime,remove the batteries to prevent possible leakage or corrosion.Pl remove the batteries during transportation to prevent it from incorrect operation